Huawei Quidway S8500 Series - Display Vsi

Command Manual – NAT&URPF&VPLS
Quidway S8500 Series Routing Switches Chapter 3
VPLS Configuration Commands
Huawei Technologies Proprietary
3-5
down: Displays the information about L2VC in Down state.
block: Displays the information about L2VC in Block state.
Description
Use the display mpls l2vc command to display the information about MPLS-based
L2VCs. You specify an interface to view the L2VC information about the VSI bound to
the interface. You can also specify a VPLS instance or a virtual connection status to
view the corresponding L2VC information.
Related command: vsi, l2 binding vsi.
Example
# View the L2VC information about the VPLS instance Huawei.
[Quidway] display mpls l2vc
Total l2vc : 3
l2vc : 1 up
l2vc : 0 block
l2vc : 2 down
Interface: Vlan-interface1024, Encapsulation: ethernet, Service: VPLS
VSI name : huawei, vsi-id : 1024 , Service Status : Open
VC-ID Destination State Lcl-Label/Rmt-Label Tunnel/Index
1024 6.6.6.6 down 131072/0 ---/0
1024 8.8.8.8 up 131075/131076 LSP/0
1024 3.3.3.3 down 131074/0 ---/0
3.1.7 display vsi
Syntax
display vsi vsi-name
View
Any view
Parameter
vsi-name: Name of a VPLS instance.
Description
Use the display vsi command to display the information about one specific or all VPLS
instances.
Related command: vsi.