Command Manual – System Management
Quidway S8500 Series Routing Switches Chapter 1 File System Management Commands
Huawei Technologies Proprietary
1-20
z After upgrade of software, configuration files in flash memory may not match the
new version's software. Perform the reset saved-configuration command to
erase the old configuration files.
z If a used Ethernet Switch is applied to the new circumstance and the original
configuration files cannot meet the new requirements, the Ethernet Switch should
be configured again. Erase the original configuration files for reconfiguration.
If the configuration files do not exist in the flash memory when Ethernet Switch is
electrified and initialized, it will enter setup switch view automatically.
Related command: save, display current-configuration, display
saved-configuration.
Example
# Erase the configuration files from the flash memory of Ethernet Switch.
<Quidway> reset saved-configuration
The saved configuration will be erased.
Are you sure?[Y/N]
1.2.6 save
Syntax
save [ file-name ]
View
User view
Parameter
file-name: Name of the configuration file with the extension .cfg. It is a character string
of 5 to 56 characters.
Description
Use the save command to save the current configuration files to Flash memory.
After finishing a group of configurations and achieving corresponding functions, user
should remember to get the current configuration files stored in the flash memory.
Even if the problems like reboot and power-off occur during saving, the configuration
can be still saved to Flash.
Related command: reset saved-configuration, display current-configuration,
display saved-configuration.
Example
# Get the current configuration files stored in the flash memory.
To Next Page
Loading...
Need help?
General