Huawei Quidway S8500 Series User Manual

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 5 BGP Configuration Commands
Huawei Technologies Proprietary
5-37
5.1.41 peer enable
Syntax
peer { group-name | peer-address } enable
undo peer { group-name | peer-address } enable
View
BGP view
Parameter
group-name: Specifies the name of the peer group which specifies the entire peer
group.
peer-address: IP address of a peer, which specifies a certain peer.
Description
Use the peer enable command to enable the specified peer/peer group.
Use the undo peer enable command to disable the specified peer/peer group.
By default, BGP peer/peer group is enabled.
If the specified peer/peer group is disabled, the router will not exchange routing
information with the specified peer/peer group.
Example
# Disable the specified peer. After the configuration, the local router does not exchange
BGP routing information with the specified peer.
[Quidway-bgp] peer 18.10.0.9 group group1
[Quidway-bgp] undo peer 18.10.0.9 enable
5.1.42 peer filter-policy export
Syntax
peer group-name filter-policy acl-number export
undo peer group-name filter-policy acl-number export
View
BGP view
Parameter
group-name: Specifies the name of the peer group.
acl-number: Specifies an IP acl number, ranging from 2000 to 3999.
export: Egress filter policy. It is only applicable to peer groups.

Huawei Quidway S8500 Series Specifications

General

Brand	Huawei
Model	Quidway S8500 Series
Category	Switch
Language	English