Huawei Quidway S8500 Series - Ascii; FTP Client Commands

Command Manual – System Management
Quidway S8500 Series Routing Switches Chapter 1 File System Management Commands
Huawei Technologies Proprietary
1-28
telnet: Sets user type to Telnet.
level level: Specifies the level of Telnet users. The argument level is an integer in the
range of 0 to 3 and defaults to 0.
terminal: Sets user type to Terminal.
Description
Use the service-type command to configure a service type for a particular user.
Use the undo service-type command to cancel the specified service type for the user.
This configuration is required if you want to access FTP server through FTP from a
client.
Example
# Set user Quidway as Lan-access user.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway]local-user quidway
New local user added.
[Quidway-luser-huawei1]
[Quidway-luser-quidway] service-type lan-access
1.4 FTP Client Commands
1.4.1 ascii
Syntax
ascii
View
FTP Client view
Parameter
None
Description
Use the ascii command to configure data transmission mode as ASCII mode.
By default, the file transmission mode is ASCII mode.
Perform this command if the user needs to change the file transmission mode to default
mode.