Huawei Quidway S8500 Series - Peer Description

Command Manual – MPLS
Quidway S8500 Series Routing Switches Chapter 2 BGP/MPLS VPN Configuration Commands
Huawei Technologies Proprietary
2-31
Parameter
ip-address: Peer IP address.
vpn-instance name: Name of the created VPN instance.
Description
Use the peer default-route-advertise vpn-instance command to enable a peer to
import a default route.
Use the undo peer default-route-advertise vpn-instance to restore the
configuration.
By default, a peer does not import a default route.
This command does not require any default route in the routing table but transmits a
default route whose next hop address is itself to the peer unconditionally.
Example
# Enable the peer test to import a default route.
[Quidway-bgp] ipv4-family vpnv4
[Quidway-bgp-af-vpn] peer 10.1.1.1 default-route-advertise vpn-instance test
2.1.35 peer description
Syntax
peer { group-name | peer-address } description description-line
undo peer { group-name | peer-address } description
View
VPN-instance subaddress family view
Parameter
group-name: Name of a neighbor peer group, consisting of 1 to 47 alphanumeric
characters.
peer-address: Peer IP address, in dotted decimal format.
description-line: Description of the configuration, up to 79 characters in length.
Description
Use the peer description command to set the description of a peer (group).
Use the undo peer description command to delete the description.
By default, there is no description for a peer (group).
The peer description is independent of the peer's group description.
Related command: display bgp peer verbose and display bgp group.