Huawei Quidway S8500 Series User Manual

Command Manual – Multicast Protocol
Quidway S8500 Series Routing Switches Chapter 1 IGMP Snooping Configuration Commands
Huawei Technologies Proprietary
1-9
1.1.7 igmp-snooping group-policy
Syntax
igmp-snooping group-policy acl-number
undo igmp-snooping group-policy
View
VLAN view
Parameter
acl-number: Number of basic ACL, in the range of 2,000 to 2,999.
Description
Use the igmp-snooping group-policy command to configure the filtering rule of
multicast groups on a specified VLAN so as to control the access to IP multicast groups.
You can configure only one ACL rule for each VLAN, and the new configured rule will
replace the old one.
Use the undo igmp-snooping group-policy command to cancel the configuration.
By default, no filtering rule is set in a VLAN. In this case, a host can join any multicast
group.
Example
# Create ACL2001 and configure the flow rule for basic ACL, using the source IP
address serves as the destination multicast address.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway]acl number 2001
[Quidway-acl-basic-2001]rule 0 permit source 224.1.1.1 0
[Quidway-acl-basic-2001]quit
# Create VLAN 2.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway]vlan 2
# Configure the filtering rule of multicast groups in VLAN2.
[Quidway-vlan2]igmp-snooping group-policy 2001
# Cancel the filtering rule in VLAN2.
[Quidway-vlan2]undo igmp-snooping group-policy

Huawei Quidway S8500 Series Specifications

General

Brand	Huawei
Model	Quidway S8500 Series
Category	Switch
Language	English