Huawei Quidway S8500 Series - Query Vlanstate

Command Manual – Integrated Management
Quidway S8500 Series Routing Switches Chapter 1
HGMP V1 Configuration Commands
Huawei Technologies Proprietary
1-46
[Quidway-lanswitch3/1/3-/] query vdsllink 1
Waiting.....
======================Result of Inquiring VDSL Link======================
------------------------------LinkNo:1--------------------------------
ErrNo :0 Status :0 CfgUsRate:0M
CfgDsRate:0M ActUsRate:0M ActDsRate:0M
FailCont :0 LtRxSNR :0 LtRsCount:0
LtTxPsd :0dBm/hz RtRxSNR :0 RtRsCount:0
RtTxPSD :0dBm/hz RtHVer :0 RtSVer :0
----------------------------------End------------------------------
 Note:
This command is only applicable to the configuration of S3026V Ethernet switches on
the NMS.
1.3.23 query vlanstate
Syntax
query vlanstate
View
lanswitch view
Parameter
None.
Description
Use the query vlanstate command to query the VLAN state of the switch.
Example
# Query the VLAN state of the Ethernet switch with the position parameter of “8/1/1-/”
[Quidway-lanswitch8/1/1-/] query vlanstate
Waiting.....
the lanswtich's vlan state :Enable