Huawei Quidway S8500 Series User Manual

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-8
Description
Use the default tag command to configure the default tag that OSPF assigns to
imported routes.
Use the undo default tag command to restore the default of the default tag that OSPF
assigns to imported routes.
When OSPF imports a route found by other routing protocols in the router and uses it
as the external routing information of its own autonomous system, some additional
parameters are required, including the default cost and the default tag of the route.
Related command: default type.
Example
# Set the default tag that OSPF assigns to imported routes to 10.
[Quidway-ospf-1] default tag 10
3.1.10 default type
Syntax
default type { 1 | 2 }
undo default type
View
OSPF view
Parameter
type 1: External routes of type 1.
type 2: External routes of type 2.
Description
Use the default type command to configure the default type when OSPF imports
external routes.
Use the undo default type command to restore the default type when OSPF imports
external routes.
By default, the external routes of type 2 are imported.
OSPF specifies the two types of external routing information. The command described
in this section can be used to specify the default type when external routes are
imported.
Related command: default tag.

Huawei Quidway S8500 Series Specifications

General

Brand	Huawei
Model	Quidway S8500 Series
Category	Switch
Language	English