Command Manual – Getting Started
Quidway S8500 Series Routing Switches Chapter 1
Commands Used to Log in to Switch
Huawei Technologies Proprietary
1-26
System View: return to User View with Ctrl+Z.
[Quidway] user-interface aux 0
[Quidway-ui-aux0] stopbits 2
1.1.29 super
Syntax
super [ level ]
View
User view
Parameter
level: User level, ranging 0 to 3. The default value is 3.
Description
Use the super command to enable the user to change to user level from the current
user level. If the user has set the super password [ level level ] { simple | cipher }
password, then user password of the higher level is needed, or the former user level will
not change.
Login users are classified into four levels that correspond to the four command levels
respectively. After users of different levels log in, they can only use commands at the
levels that are equal to or lower than its own level.
Related command: super password, quit.
Example
# change to user level 3 from the current user level.
<Quidway> super 3
Password:
1.1.30 super password
Syntax
super password [ level level ] { simple | cipher } password
undo super password [ level level ]
View
System view
To Next Page
Loading...
Need help?
General