Huawei Quidway S8500 Series User Manual

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 6 IP Routing Policy Configuration Commands
Huawei Technologies Proprietary
6-14
6.1.17 if-match cost
Syntax
if-match cost value
undo if-match cost
View
Route policy view
Parameter
value: Specifies the required route metric value, ranging from 0 to 4294967295.
Description
Use the if-match cost command to configure one of the match rules of the route-policy
to match the cost of the routing information.
Use the undo if-match cost command to cancel the configuration of the match rule.
By default, no if-match sub-statement is defined.
This is an if-match sub-statement of Route-policy, used to specify the cost of a route
matches the specified condition.
Related command: if-match interface, if-match acl, if-match ip-prefix, if-match ip
next-hop, if-match tag, route-policy, apply ip next-hop, apply local-preference,
apply cost, apply origin, apply tag.
Example
# Define an if-match sub-statement, allowing the routing information with routing cost of
8 to pass this if-match sub-statement.
[Quidway-route-policy] if-match cost 8
6.1.18 if-match interface
Syntax
if-match interface interface-type interface-number
undo if-match interface
View
Route policy view
Parameter
interface-type: Specifies interface type.
interface-number: Specifies interface number.

Huawei Quidway S8500 Series Specifications

General

Brand	Huawei
Model	Quidway S8500 Series
Category	Switch
Language	English