Huawei Quidway S8500 Series User Manual

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 5 BGP Configuration Commands
Huawei Technologies Proprietary
5-9
Use the debugging bgp keepalive command to enable the information debugging of
BGP Keepalive packets.
Use the debugging bgp packet command to enable the information debugging of
BGP packets.
Use the undo debugging bgp command to disable the debugging functions.
Example
# Enable the information debugging of BGP packets.
<Quidway> debugging bgp packet
5.1.10 default local-preference
Syntax
default local-preference value
undo default local-preference
View
BGP view
Parameter
value: Default local preference to be configured. The range is 0 to 4294967295. By
default, its value is 100.
Description
Use the default local-preference command to configure the local preference.
Use the undo default local-preference command to restore the default value.
Configuring different local preferences will affect BGP routing selection.
Example
# The two routers RTA and RTB in the same autonomous area connect with external
autonomous areas. The command can be used to configure the default local
preference of RTB as 180 so that the route via RTB is selected first when the same
route goes through RTA and RTB at the same time.
[Quidway-bgp]default local-preference 180
5.1.11 default med
Syntax
default med med-value
undo default med

Huawei Quidway S8500 Series Specifications

General

Brand	Huawei
Model	Quidway S8500 Series
Category	Switch
Language	English