Huawei Quidway S8500 Series - Display Local-User

Command Manual – Security
Quidway S8500 Series Routing Switches
Chapter 2 AAA and RADIUS/HWTACACS Protocol
Configuration Commands
Huawei Technologies Proprietary
2-7
<Quidway> display domain
0 Domain = system
State = Active
Scheme = LOCAL Access-limit = Disable
Vlan-assignment-mode = Integer
Domain User Template:
Idle-cut = Disable
Self-service = Disable
Default Domain Name: system
Total 1 domain(s).1 listed.
2.1.7 display local-user
Syntax
display local-user [ domain isp-name | idle-cut { enable | disable } | service-type
{ ftp | lan-access | ppp | ssh | telnet | terminal } | state { active | block } | user-name
user-name | vlan vlanid ]
View
Any view
Parameter
domain isp-name: Configures to display all the local users in the specified ISP domain.
isp-name specifies the ISP domain name with a character string not exceeding 24
characters. The specified ISP domain shall have been created.
idle-cut: Configures to display the local users according to the state of idle-cut function.
disable means that the user disables the idle-cut function and enable means the user
enables the function. This parameter only takes effect on the users configured as
Lan-access type. For other types of users, the display local-user idle-cut enable and
display local-user idle-cut disable commands will not display any information.
service-type: Configures to display local user of a specified type.
ftp means that the specified user type is FTP.
lan-access means that the specified user type is Lan-access which mainly refers to
Ethernet accessing users, 802.1x supplicants for example.
ppp: Specifies PPP users.
ssh: Specifies SSH users.
telnet: Specifies Telnet users.
terminal: Specifies terminal users.