Command Manual – QoS/ACL
Quidway S8500 Series Routing Switches Chapter 2 QoS Commands
Huawei Technologies Proprietary
2-24
Example
# Configure mirroring group 1, the monitored ports are Ethernet3/1/1 to Ethernet3/1/3,
and the monitoring port is Ethernet3/1/4, monitoring only inbound packets.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] mirroring-group 1 inbound ethernet 3/1/1 ethernet 3/1/2 ethernet
3/1/3 mirrored-to ethernet 3/1/4
If the mirroring-group has been configured, the system will prompt “The mirroring-group
has been configured!”
2.1.25 priority
Syntax
priority priority-level
undo priority
View
Ethernet port view
Parameter
priority-level: Port priority value, in the range of 0 to 7. By default, it is 0.
Description
Use the priority command to set the default local precedence value for a port.
Use the undo priority command to restore the default value of local precedence.
After receiving a packet, the switch allocates a set of service parameters to it according
to a specific rule. The procedure to obtain local precedence: First obtain it according to
the “CoS —>Local-precedence” mapping table. If failed, the system uses the default
local precedence of the port as that for the packet.
Example
# Set the defaulted local precedence value of the port Ethernet3/1/1 as 7.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway]interface e thernet3/1/1
[Quidway-Ethernet3/1/1] priority 7
2.1.26 qos conform-level
Syntax
To Next Page
Loading...
Need help?
General