Command Manual – Multicast Protocol
Quidway S8500 Series Routing Switches Chapter 6 MSDP Configuration Commands
Huawei Technologies Proprietary
6-13
Related command: peer.
Example
# Configure the TTL threshold value to 10, i.e., only those multicast data packets with a
TTL value greater than or equal to 10 can be forwarded to the MSDP peer 110.10.10.1.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] msdp
[Quidway-msdp] peer 110.10.10.1 minimum-ttl 10
6.1.15 peer request-sa-enable
Syntax
peer peer-address request-sa-enable
undo peer peer-address request-sa-enable
View
MSDP view
Parameter
peer-address: Address of MSDP peer.
Description
Use the peer request-sa-enable command to enable the router to send SA request
message to the specified MSDP peer when receiving a new group join message.
Use the undo peer request-sa-enable command to remove the configuration.
By default, when receiving a new group join message, the router sends no SA request
messages to MSDP peers but waits to receive the next SA message.
Related command: cache-sa-enable.
Example
# Configure to send SA request message to the MSDP peer 125.10.7.6.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] msdp
[Quidway-msdp] peer 125.10.7.6 request-sa-enable
6.1.16 peer sa-cache-maximum
Syntax
peer peer-address sa-cache-maximum sa-limit
To Next Page
Loading...
