Command Manual – Security
Quidway S8500 Series Routing Switches
Chapter 2 AAA and RADIUS/HWTACACS Protocol
Configuration Commands
Huawei Technologies Proprietary
2-30
session-id session-id: Configures to display the saved stopping accounting requests
according to the Session ID. session-id specifies the Session ID with a character string
not exceeding 50 characters.
time-range start-time stop-time: Configures to display the saved stopping accounting
requests according to the saving time. start-time specifies the start time of the saving
time range and stop-time specifies the stop time of the saving time range. The time is
expressed in the format hh:mm:ss-yyyy/mm/dd. When this parameter is specified, all
the stopping accounting requests saved in the time range since start-time to stop-time
will be displayed.
user-name user-name: Configures to display the saved stopping accounting requests
according to the username. User-name specifies the username, a character string not
exceeding 32 characters, excluding “/”, “:”, “*”, “?”, “<” and “>”. The @ character can
only be used once in one username. The pure username (the part before @, namely
the user ID) cannot exceed 24 characters.
Description
Use the display stop-accounting-buffer command to view the stopping accounting
requests, which have not been responded and saved in the buffer. You can select to
display the packets sent to a certain RADIUS scheme, or display the packets according
to user Session ID or username. You may also display the request packets saved
during a specified time range. The displayed packet information can help with diagnosis
and troubleshooting.
After transmitting the stopping accounting requests, if there is no response from the
RADIUS scheme, the switch will save the packet in the buffer and retransmit it for
several times, which is set through the retry stop-accounting command.
Related command: reset stop-accounting-buffer, stop-accounting-buffer enable,
retry stop-accounting.
Example
# Display the stopping accounting requests saved in the system buffer since 0:0:0 to
23:59:59 on August 31, 2002.
<Quidway> display stop-accounting-buffer time-range 0:0:0-2002/08/31
23:59:59-2002/08/31
Total find 0 record
2.2.9 key
Syntax
key { accounting | authentication } string
undo key { accounting | authentication }
To Next Page
Loading...
