Huawei Quidway S8500 Series - Display CCC; Static-Lsp Egress L2 Vpn

Command Manual – MPLS
Quidway S8500 Series Routing Switches Chapter 3 MPLS L2VPN Configuration Commands
Huawei Technologies Proprietary
3-3
3.1.3 display ccc
Syntax
display ccc [ ccc-name | type [ local | remote ] ]
View
Any view
Parameter
ccc-name: Name of the CCC connection whose information is to be displayed.
type local: Displays information about the local CCC connections only.
type remote: Displays information about the remote CCC connections only.
Description
Use the display ccc command to display the information about specified CCC
connections.
Example
# Display information about the CCC connection named c-link.
<Quidway> display ccc c-link
name: c-link, type: remote, state: down,
intf: Vlan-interface1003 (down), tran-lsp: ccc2 (up), rcv-lsp: ccc1 (up)
3.1.4 static-lsp egress l2vpn
Syntax
static-lsp egress lsp-name l2vpn incoming-interface vlan-interface vlan-id in-label
in-label
undo static-lsp egress lsp-name
View
MPLS view
Parameter
lsp-name: Name of the label switching path (LSP).
vlan-id: ID of the VLAN whose interface is to be used to create the LSP.
in-label-value: Value of the in-label, ranging from 16 to 1,023.