Huawei Quidway S8500 Series - Display Interface Vlan-Interface

Command Manual – VLAN&QinQ
Quidway S8500 Series Routing Switches Chapter 1
VLAN Configuration Commands
Huawei Technologies Proprietary
1-2
Parameter
None
Description
Use the display trap-to-cpu command to view the related information about the CPU
port.
Example
# Display related information about the CPU port
<Quidway> display trap-to-cpu
trap-to-cpu disable vlan 2 10 14 to 15
1.1.3 display interface Vlan-interface
Syntax
display interface Vlan-interface [ vlan-id ]
View
Any view
Parameter
vlan-id: Specifies VLAN ID.
Description
Use the display interface Vlan-interface command to view the related information
about specified or all VLAN interfaces, including physical protocol status and link
protocol status of VLAN interface, Ethernet sending frame format, MAC address, IP
address and sub-net mask, description character string and MTU, etc.
With vlan-id specified, only the information about the specified VLAN interface will be
displayed. If no vlan-id is specified, the information about all the existing VLAN
interfaces will be displayed.
Related command: interface vlan-interface.
Example
# Display related information about VLAN-interface 1.
<Quidway> display interface Vlan-interface 1
Vlan-interface1 current state : DOWN
Line protocol current state : DOWN
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is
00e0-fc07-4101
Internet Address is 10.1.1.1/24 Primary