Huawei Quidway S8500 Series User Manual

Command Manual – Port
Quidway S8500 Series Routing Switches Chapter 3 POS Port Configuration Commands
Huawei Technologies Proprietary
3-14
Description
Use the threshold command to set the thresholds of SD (signal degrade) and SF
(signal failure) alarms.
Use the undo threshold command to restore the defaults.
Note that SD threshold must smaller than SF threshold
Example
# Set the threshold of SD to 4.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface pos2/1/1
[Quidway-Pos2/1/1] threshold sd 4
3.1.17 timer hold
Syntax
timer hold seconds
undo timer hold
View
POS port view
Parameter
seconds: Polling interval, in units of second and in the range of 0 to 32,767. By default,
it is 10 seconds. 0 means the system does not perform link validity check.
Description
Use the timer hold command to set polling interval for the status timer at the POS port.
Use the undo timer hold command to restore the default polling interval.
You must set consistent polling interval at the both ends. If you set the polling interval at
both ends as 0, the system does not perform link validity check.
Example
# Set the polling interval at POS2/1/1 to 20 seconds.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface pos2/1/1
[Quidway-Pos2/1/1] timer hold 20

Huawei Quidway S8500 Series Specifications

General

Brand	Huawei
Model	Quidway S8500 Series
Category	Switch
Language	English