Huawei Quidway S8500 Series - Display Pim Routing-Table

Command Manual – Multicast Protocol
Quidway S8500 Series Routing Switches Chapter 5 PIM Configuration Commands
Huawei Technologies Proprietary
5-11
5.1.11 display pim routing-table
Syntax
display pim routing-table [ { { *g [ group-address [ mask { mask-length | mask } ] ] |
**rp [ rp-address [ mask { mask-length | mask } ] ] } | { group-address [ mask
{ mask-length | mask } ] | source-address [ mask { mask-length | mask } ] } * } |
incoming-interface { interface interface-type interface-number | null } |
{ dense-mode | sparse-mode } ] *
View
Any view
Parameter
*g: (*, G) route entry.
mask: IP address mask.
mask-length: Length of the IP address mask.
**rp: (*, *, p) route entry.
rp-address: Address of the RP.
group-address: Address of the multicast group.
source-address: IP address of the multicast source.
incoming-interface interface interface-type interface-number: Route entry with the
specified incoming interface.
null: Specifies the incoming interface type as Null.
dense-mode: Specifies the multicast routing protocol as PIM-DM.
sparse-mode: Specifies the multicast routing protocol as PIM-SM.
Description
Use the display pim routing-table command to view the contents of the PIM multicast
routing table. The displayed information of the PIM multicast routing table includes the
SPT and RPF information.
Example
# View the contents of the PIM multicast routing table on the router.
<Quidway> display pim routing-table
PIM-SM Routing Table
Total 0 (*,*,RP)entry, 0 (*,G)entry, 2 (S,G)entries
(192.168.1.2, 224.2.178.130),
Protocol 0x20: PIMSM, Flag 0x4: SPT