Command Manual – Integrated Management
Quidway S8500 Series Routing Switches Chapter 1
HGMP V1 Configuration Commands
Huawei Technologies Proprietary
1-18
Turning a faulty Ethernet switch to inactive can prevent its information from being
displayed, making the output information more clear.
Normally, only faulty Ethernet switches can be turned to inactive.
Related command: display lanswitch.
Example
# Turn the Ethernet switch connected to the 0/1/6 port to active.
[Quidway-hgmp] set lanswitch 0/1/6-/ active
1.1.16 set lswconfig
Syntax
set lswconfig lanswitch-loc asdefault
View
HGMP view
Parameter
lanswitch-loc: Ethernet switch position parameter.
Description
Use the set lswconfig command to specify the configuration settings of an Ethernet
switch to be the default settings of the Ethernet switches that are of the same model.
You can use the auto config command to configure other Ethernet switches that are of
the same model using the default settings.
Related command: auto config.
Example
# Specify the configuration settings of the Ethernet switch connected to 0/1/6-/ port as
the default configuration settings of the Ethernet switches that are of the same model.
[Quidway-lanswitch0/1/6-/] set lswconfig 0/1/6-/ asdefault
1.1.17 set lswname
Syntax
set lswname lanswitch-loclist name-list
undo set lswname lanswitch-loclist
View
HGMP view
To Next Page
Loading...
