Huawei Quidway S8500 Series User Manual

Command Manual – Getting Started
Quidway S8500 Series Routing Switches Chapter 1
Commands Used to Log in to Switch
Huawei Technologies Proprietary
1-25
Description
Use the speed command to configure the transmission rate on the user interface.
Use the undo speed command to restore the default rate.
This command can only be performed in Console and AUX user interface view.
Note that AUX user interface does not support the transmission rate: 57600bit/s and
115200bit/s.
Example
# Configure the transmission speed on the AUX port as 9600bit/s.
<Quidway>system-view
System View: return to User View with Ctrl+Z.
[Quidway] user-interface aux 0
[Quidway-ui-aux0] speed 9600
1.1.28 stopbits
Syntax
stopbits { 1 | 1.5 | 2 }
undo stopbits
View
User interface view
Parameter
1: Sets 1 stop bit.
1.5: Sets 1.5 stop bits.
2: Sets 2 stop bits.
Description
Use the stopbits command to configure the stop bits on the user interface.
Use the undo stopbits command to restore the default stop bits.
This command can only be performed in Console and AUX user interface view.
By default, the value is 1.
Note that setting 1.5 stop bits is not available on Quidway S8500 Series Routing
Switches at present.
Example
# Set stop bits to 2.
<Quidway>system-view

Huawei Quidway S8500 Series Specifications

General

Brand	Huawei
Model	Quidway S8500 Series
Category	Switch
Language	English