Command Manual – Security
Quidway S8500 Series Routing Switches
Chapter 2 AAA and RADIUS/HWTACACS Protocol
Configuration Commands
Huawei Technologies Proprietary
2-10
complete set of exclusive ISP domain attributes for each ISP domain, which includes
AAA schemes ( RADIUS scheme group applied and so forth.)
For a switch, each supplicant belongs to an ISP domain. The system supports to
configure up to 16 ISP domains.
When this command is used, if the specified ISP domain does not exist, the system will
create a new ISP domain. All the ISP domains are in the active state when they are
created.
Related command: access-limit, radius scheme, state, display domain.
Example
# Create a new ISP domain, huawei163.net, and enters its view.
[Quidway] domain huawei163.net
New Domain added.
[Quidway-isp-huawei163.net]
2.1.9 idle-cut
Syntax
idle-cut { disable | enable minute flow }
View
ISP domain view
Parameter
disable: means disabling the user to use idle-cut function.
enable: means enabling the user to use idle-cut function.
minute: Specifies the maximum idle time, ranging from 1 to 120 and measured in
minutes.
flow: Minimum data traffic, ranging from 1 to 10,240,000 and measured in bytes.
Description
Use the idle-cut command to configure the user template in the current ISP domain.
By default, after an ISP domain is created, this attribute in user template is disable, that
is, the user Idle-cut is disabled.
The user template is a set of default user attributes. If a user requesting for the network
service does not have some required attributes, the corresponding attributes in the
template will be endeavored to him as default ones. The user template of the switch
you are using may only provide user Idle-cut settings. After a user is authenticated, if
the Idle-cut is configured to enable or disable by neither the user nor the RADIUS
server, the user will adopt the Idle-cut state in the template.
To Next Page
Loading...
