Command Manual – Getting Started
Quidway S8500 Series Routing Switches Chapter 1
Commands Used to Log in to Switch
Huawei Technologies Proprietary
1-19
Example
# Set the Telnet protocol to be used for user login.
<Quidway>system-view
System View: return to User View with Ctrl+Z.
[Quidway] user-interface vty 0
[Quidway-ui-vty0] protocol inbound telnet
1.1.20 quit
Syntax
quit
View
Any view
Parameter
None
Description
Use the quit command to return to the lower level view from the current view. If the
current view is user view, you can quit the system.
There are three levels of views, which are listed from low to high as follows:
z User view
z System view
z VLAN view, Ethernet port view, and so on.
Related command: see return, system-view.
Example
# Return to user view from system view.
[Quidway] quit
<Quidway>
1.1.21 return
Syntax
return
View
System view or above
To Next Page
Loading...
