Huawei Quidway S8500 Series - Apply Cost-Type; Apply Ip Next-Hop

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 6 IP Routing Policy Configuration Commands
Huawei Technologies Proprietary
6-4
6.1.4 apply cost-type
Syntax
apply cost-type [ internal | external ]
undo apply cost-type
View
Route policy View
Parameter
internal: For BGP, it indicates when a BGP peer advertises routes to its EBGP peer, the
peer uses the cost value of IGP as the MED value of BGP. For IS-IS, it indicates the
internal cost. For other protocols, it is invalid.
external: It is only valid for IS-IS and it indicates external cost type of IS-IS.
Description
Use the apply cost-type command to configure the route cost type of route information.
Use the undo apply cost-type command to cancel the Apply sub-statement.
By default, route cost type is not set.
Example
# Set the cost type of IGP as MED value of BGP.
[Quidway-route-policy] apply cost-type internal
6.1.5 apply ip next-hop
Syntax
apply ip next-hop ip-address
undo apply ip next-hop
View
Route policy view
Parameter
ip-address: The next-hop address.
Description
Use the apply ip next-hop command to configure the next hop address in the route
information.
Use the undo apply ip next-hop command to cancel the Apply sub-statement.