Command Manual – VLAN&QinQ
Quidway S8500 Series Routing Switches Chapter 1
VLAN Configuration Commands
Huawei Technologies Proprietary
1-9
Parameter
interface-list: List of Ethernet ports, expressed as interface-list= { interface-type
interface-number [ to { interface-type interface-number ] }&<1-10>. interface-type is
interface type, interface-number is interface number. The interface number after the
keyword to must be larger than or equal to the interface number before to. &<1-10>
represents that the preceding parameter can be repeated up to 10 times.
Description
Use the port command to add one port or one group of ports to VLAN.
Use the undo port command to cancel one port or one group of ports from VLAN.
Note that you can add/delete trunk port and hybrid port to/from VLAN by the port and
undo port commands in Ethernet port view, but not in VLAN view.
Related command: display vlan.
Example
# Add Ethernet2/1/1 through Ethernet2/1/3 to VLAN 2.
[Quidway-vlan2] port ethernet2/1/1 to ethernet2/1/3
1.3 Protocol-Based VLAN Configuration Commands
1.3.1 display protocol-vlan interface
Syntax
display protocol-vlan interface { interface-list | all }
View
Any view
Parameter
interface-list: Displays the protocol information of a specified interface, in the form of
interface-list = { interface-type interface-number [ to interface-type
interface-number ] }&<1-10>. interface-type is interface type, interface-number is
interface number. The interface number after the keyword to must be larger than or
equal to the interface number before to. &<1-10> represents that the preceding
parameter can be repeated up to 10 times.
all: Displays the protocol information of all ports.
Description
Use the display protocol-vlan interface command to view the protocol information
and protocol index configured on the specific port, to which you can refer when you use
the protocol-based VLAN and add/delete a protocol.
To Next Page
Loading...
Need help?
General