Huawei Quidway S8500 Series - Flow-Control; Link-Status Hold

Command Manual – Port
Quidway S8500 Series Routing Switches Chapter 1 Ethernet Port Configuration Commands
Huawei Technologies Proprietary
1-10
1.1.9 flow-control
Syntax
flow-control
undo flow-control
View
Ethernet port view
Parameter
None
Description
Use the flow-control command to enable flow control feature on the Ethernet port to
avoid discarding data packets due to congestion.
Use the undo flow-control command to disable flow control feature.
By default, flow control on the Ethernet port is disabled.
Example
# Enable flow control on Ethernet2/1/1.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface Ethernet 2/1/1
[Quidway-Ethernet2/1/1] flow-control
1.1.10 link-status hold
Syntax
link-status hold hold-time
undo link-status hold
View
System view
Parameter
hold-time: Sets time interval (in seconds) for port suppression. The value 0 indicates
that port suppression is not enabled. By default, the time interval is 3 seconds.