Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 4 Integrated IS-IS Configuration Commands
Huawei Technologies Proprietary
4-5
undo default-route-advertise [ route-policy route-policy-name ]
View
IS-IS view
Parameter
route-policy-name: Name of a route-policy.
Description
Use the default-route-advertise command to create the default route of L1, L2 router.
Use the undo default-route-advertise command to cancel this configuration.
By default, this command uses the L2 router to create the default route. There is
another mechanism for L1 routers. Namely, the system discovers the default route by
searching the nearest L1/L2 router. The nearest L1/L2 router can be found by
searching the ATT bit in the L1 LSP.
This command can be set on L1 router or L2 router. By default, the route is generated
on L2 LSP. If the apply isis level-1 command is executed in route-policy view, the
default route will be generated on L1 LSP. If the apply isis level-2 command is
executed in Route-policy view, the default route will be generated on L2 LSP. If the
apply isis level-1-2 command is executed in route-policy view, the default route will be
generated on both L1 LSP and L2 LSP.
Example
# Set the router to create the default route in the LSP of correspond level.
[Quidway-isis] default-route-advertise
4.1.5 display isis interface
Syntax
display isis interface [ verbose ]
View
Any view
Parameter
verbose: If this parameter is used, the details of the interface will be displayed.
Description
Use the display isis interface command to view the information of the enabled IS-IS
interface.
To Next Page
Loading...
Need help?
General