Huawei Quidway S8500 Series - Igmp-Snooping Nonflooding-Enable

Command Manual – Multicast Protocol
Quidway S8500 Series Routing Switches Chapter 1 IGMP Snooping Configuration Commands
Huawei Technologies Proprietary
1-11
Description
Use the igmp-snooping max-response-time command to configure the maximum
response time for a query.
Use the undo igmp-snooping max-response-time command to restore the default
value.
The set maximum response time decides the time limit for the switch to respond to
IGMP Snooping query packets.
Related command: igmp-snooping and igmp-snooping router-aging-time.
Example
# Set the maximum response time for the IGMP Snooping packet to 15s.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] igmp-snooping max-response-time 15
1.1.10 igmp-snooping nonflooding-enable
Syntax
igmp-snooping nonflooding-enable
undo igmp-snooping nonflooding-enable
View
System view
Parameter
None
Description
Use the igmp-snooping nonflooding-enable command to enable unknown multicast
data packets not to be broadcasted within a VLAN.
Use the undo igmp-snooping nonflooding-enable command to disable unknown
multicast data packets not to be broadcasted within a VLAN.
Note that if IGMP snooping is not enabled on the VLAN (nor Layer 3 multicast),
unknown multicast packets are broadcasted within the VLAN no matter whether this
function is enabled or not. To make unknown multicast data packets not be
broadcasted within the VLAN, you need to enable igmp-snooping in this VLAN and
enable igmp-snooping nonflooding-enable globally.
By default, unknown multicast data packets are broadcasted within the VLAN.