Huawei Quidway S8500 Series - Ntp-Service Source-Interface

Command Manual – System Management
Quidway S8500 Series Routing Switches Chapter 7 NTP Configuration Commands
Huawei Technologies Proprietary
7-12
undo ntp-service reliable authentication-keyid number
View
System view
Parameter
number: Specifies the key number, ranging from 1 to 4294967295.
Description
Use the ntp-service reliable authentication-keyid command to configure the key as
reliable.
Use the undo ntp-service reliable authentication-keyid command to cancel the
current setting.
By default, no key is configured as reliable.
When you enable the authentication, you can use this command to configure one or
more than one keys as reliable. In this case, a Client will only get synchronized by a
server whichever can provide a reliable key.
Example
# Enable NTP authentication, adopt MD5 encryption, and designate Key 37 BetterKey
and configure it as reliable.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] ntp-service authentication enable
[Quidway] ntp-service authentication-keyid 37 authentication-mode md5
BetterKey
[Quidway] ntp-service reliable authentication-keyid 37
7.1.15 ntp-service source-interface
Syntax
ntp-service source-interface interface-type interface-number
undo ntp-service source-interface
View
System view
Parameter
interface-type: Specifies the interface type and determine an interface with the
interface-number parameter. The interface can be VLAN interface and Loopback
interface currently.