Command Manual – Integrated Management
Quidway S8500 Series Routing Switches Chapter 1
HGMP V1 Configuration Commands
Huawei Technologies Proprietary
1-20
As mentioned earlier, HGMP identifies each Ethernet switch using the corresponding
switch position parameter. You can enable a management device to automatically
retrieve the position parameters of the Ethernet switches in the network connected to a
port of the management device by specifying the network to be of star topology.(A
position parameter is a string that comprises slot number, subslot number, port number,
and sequence number. It does not identify the physical position of an Ethernet switch.)
Example
# Specify the network connected to the 1/1/1 port of the management device to be of
star topology.
[Quidway-hgmp] spanning-hub enable 1 1 1
Changing port mode will cause lanswitch data to be lost, are you sure? [n]y
[Quidway-hgmp]
1.1.19 upgrade lanswitch
Syntax
upgrade lanswitch lanswitch-loc { app | bootrom }
View
HGMP view
Parameter
lanswitch-loc: Ethernet switch position parameter, a string that comprises slot number,
subslot number, port number, and sequence number. This argument does not identify
the physical position of an Ethernet switch.
app: Specifies to upgrade the applications of an Ethernet switch.
bootrom: Specifies to upgrade the Boot ROM of an Ethernet switch.
Description
Use the upgrade lanswitch command to upgrade a specified Ethernet switch.
It is a heavy burden for maintainers to upgrade Ethernet switches manually. This
command enables them to upgrade specified Ethernet switches remotely, which
improves the maintenance efficiency and eases workload remarkably.
Before upgrading an Ethernet switch connected to the management device, you need
to load the corresponding upgrade program to the management device using the load
lswprogram command.
Related command: load lswprogram.
To Next Page
Loading...
Need help?
General