Command Manual – Port
Quidway S8500 Series Routing Switches Chapter 6 Port Isolation Configuration Commands
Huawei Technologies Proprietary
6-3
Note that:
z You can configure isolated ports for the isolated group only after you create the
isolated group.
z An isolated port can only be an Ethernet port or RPR logic port.
z An isolated port cannot serve as both an isolated port and an uplink port in the
same isolated group.
z The number of isolated ports in an isolated group is not limited
Example
# Configure port Ethernet3/1/1 as an isolated port of isolated group 1.
<Quidway> system-view
[Quidway]interface Ethernet3/1/1
[Quidway-Ethernet3/1/1] port-isolate group 1
6.1.4 display port-isolate group
Syntax
display port-isolate group [ isolate-group-id ] [ verbose ]
View
Any view
Parameter
isolate-group-id: Isolated group number, ranging from 1 to 64. The system supports 64
isolated groups.
Description
Use the display port-isolate group command to display configuration information of
an isolated group. If you do not specify the isolated group number, the system displays
the configuration information of all the isolated groups. If you choose the verbose
keyword, the system displays the information about isolated ports and upstream port of
the isolated group, and VLAN information of each port.
Example
# Display configuration information of all isolated groups.
<Quidway> display port-isolate group
Now, the following port-isolate-group exist(s): 1,2-10,14
Port-isolate-group ID: 1
Uplink-port: Ethernet3/1/1
Isolate-Port(s): Ethernet3/1/2, Ethernet3/1/3
To Next Page
Loading...
Need help?
General