Huawei Quidway S8500 Series User Manual

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 2 RIP Configuration Commands
Huawei Technologies Proprietary
2-10
2.1.12 rip
Syntax
rip
undo rip
View
system view
Parameter
None
Description
Use the rip command to enable the RIP and enter the RIP view.
Use the undo rip command to disable RIP.
By default, the system does not run RIP.
To enter the RIP view to configure various RIP global parameters, RIP should be
enabled first. Whereas the configuration of parameters related to the interfaces is not
restricted by enabling/disabling RIP.
 Note:
Note that the interface parameters configured previously would be invalid when RIP is
disabled.
Example
# Enable the RIP and enter the RIP view.
[Quidway] rip
[Quidway-rip]
2.1.13 rip authentication-mode
Syntax
rip authentication-mode { simple password | md5 { usual key-string | nonstandard
key-string key-id } }
undo rip authentication-mode

Huawei Quidway S8500 Series Specifications

General

Brand	Huawei
Model	Quidway S8500 Series
Category	Switch
Language	English