Huawei Quidway S8500 Series - Rpr Protect-Mode; Rpr Rate-Limit

Command Manual – Port
Quidway S8500 Series Routing Switches Chapter 4 RPR Port Configuration Commands
Huawei Technologies Proprietary
4-21
Example
# Configure Tag priorities 6 and 7 as class A service, priorities 2, 3, 4 and 5 as class B
service, and priorities 0 and 1 as class C service.
<Quidway> system-view
[Quidway] interface RPRPOS3/1/1
[Quidway-RPRPOS3/1/1]rpr cos-precedence-map tag 2 2 1 1 1 1 0 0
4.1.19 rpr protect-mode
Syntax
rpr protect-mode { steer | wrap }
undo rpr protect-mode
View
RPR logical port view
Parameter
steer: The source node sends data in another direction for protection.
wrap: The failure node sends data in loopback mode for protection.
Description
Use the rpr protect-mode command to configure node protection mode as Steer or
Wrap. The default mode is Steer.
Use the undo rpr protect-mode command to restore the steer RPR protection mode.
Example
# Set the RPR protection mode to Wrap.
<Quidway> system-view
[Quidway] interface RPRPOS3/1/1
[Quidway-RPRPOS3/1/1] rpr protect-mode wrap
4.1.20 rpr rate-limit
Syntax
rpr rate-limit { high | low | medium | reserved } { ringlet0 | ringlet1 } value
undo rpr rate-limit { high | low | medium | reserved } { ringlet0 | ringlet1 }
View
RPR logical port view