Huawei Quidway S8500 Series - Register-Policy

Command Manual – Multicast Protocol
Quidway S8500 Series Routing Switches Chapter 5 PIM Configuration Commands
Huawei Technologies Proprietary
5-19
 Note:
z You must enable a PIM protocol (PIM-DM or PIM-SM) in VLAN interface view before
you can proceed with this configuration.
z When you configure the time interval for a port to send Hello packets, the PIM
neighbor hold-time value is automatically set to 3.5 times the Hello interval.
Therefore you need not configure the PIM neighbor hold-time separately.
Example
# Set the time interval to send Hello packets for VLAN-interface10 to 40 seconds.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway]interface vlan-interface 10
[Quidway-Vlan-interface10] pim timer hello 40
5.1.20 register-policy
Syntax
register-policy acl-number
undo register-policy
View
PIM view
Parameter
acl-number: Number of IP advanced ACL, defining the rule of filtering the source and
group addresses. The value ranges from 3000 to 3999.
Description
Use the register-policy command to configure a RP to filter the register messages
sent by the DR in the PIM-SM network and to accept the specified messages only.
Use the undo register-policy command to remove the configured message filtering.
Example
# If the local device is the RP in the network, using the following command can only
accept multicast message register of the source sending multicast address in the range
of 225.1.0.0/16 on network segment 10.10.0.0/16.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] acl number 3010