Huawei Quidway S8500 Series - Chapter 1 Poe Configuration Commands

Command Manual – PoE
Quidway S8500 Series Routing Switches Chapter 1 PoE Configuration Commands
Huawei Technologies Proprietary
1-1
Chapter 1 PoE Configuration Commands
1.1 PoE Configuration Commands
1.1.1 display poe interface
Syntax
display poe interface { interface-name | interface-type interface-num }
View
Any view
Parameter
interface-name | interface-type interface-num: Port on the switch; refer to Command
Manual – Port for details.
Description
Use the display poe interface{ interface-name | interface-type interface-num }
command to display the PoE status of a specific port on the switch.
Use the display poe interface command without any option to display the PoE status
of all the PoE-capable ports on the switch.
Example
# Display the PoE status of the port GigabitEthernet3/1/1.
<Quidway> display poe interface GigabitEthernet3/1/1
Port power status :delivering
Port power mode :signal
Port PD class :2
port power priority :high
Port max power :16800 mW
Port current power :552 mW
Port remaining power :16248 mW
Port average power :717 mW
Port peak power :1196 mW
Port current :13 mA
Port voltage :53.7 V