Command Manual – Integrated Management
Quidway S8500 Series Routing Switches Chapter 1
HGMP V1 Configuration Commands
Huawei Technologies Proprietary
1-3
Parameter
port-start-vlanid: Starting ID of the VLAN the port belongs to.
Note that as VLAN 2047 is reserved, it is automatically skipped if it is among those to
be automatically configured.
Description
Use the auto config command to configure switches using the default configuration
settings. You can use the set lswconfig command to specify the default configuration
settings. If the default configuration settings do not exist, this command configures the
connected switches using the factory settings.
Related command: query port, query vlan.
Example
# Configure the switches using the factory settings with VLAN2000 as the starting
VLAN ID.
[Quidway-lanswitch3/1/6-/] auto config default 2000
Auto config will clean previous configuration, are you sure? [n]y
Waiting......
Auto config LANSWITCH[3/1/6-/] successfully!
1.1.2 backup lswconfig
Syntax
backup lswconfig
View
HGMP view
Parameter
None
Description
Use the backup lswconfig command to save the configuration information retrieved
by the save lswconfig command to the flash memory. As data saved in the flash
memory does not get lost even if the management device reboots, you can restore the
configuration of an Ethernet using the configuration information previously saved in the
flash memory.
Related command: save lswconfig.
Example
To Next Page
Loading...
