Command Manual – STP
Quidway S8500 Series Routing Switches Chapter 1
MSTP Configuration Commands
Huawei Technologies Proprietary
1-25
Example
# Set the mcheck parameter of Ethernet2/1/3 in system view.
<Quidway>system-view
System View: return to User View with Ctrl+Z.
[Quidway] stp interface Ethernet2/1/3 mcheck
1.1.23 stp interface point-to-point
Syntax
stp interface interface-list point-to-point { force-true | force-false | auto }
undo stp interface interface-list point-to-point
View
System view
Parameter
interface-list: Ethernet port list, containing multiple Ethernet ports and expressed as
interface-list = { interface-type interface-number [ to interface-type
interface-number ] }&<1-10>. For detail descriptions of interface-type and
interface-number parameters, refer to the corresponding descriptions in Port
Command Manual. &<1-10> means that the preceding parameters can be entered up
to 10 times.
force-true: Indicates the Ethernet port connected to a point-to-point link.
force-false: Indicates the Ethernet port not connected to a point-to-point link.
auto: Configures to automatically check if the link to the Ethernet port is a point-to-point
link.
Description
Use the stp interface point-to-point command to configure a port (not) to be
connected to a point-to-point link in system view.
Use the undo stp interface point-to-point command to restore the default state of the
link to the Ethernet port.
By default, the parameter defaults to auto, that is, MSTP checks if the link to the
Ethernet port is a point-to-point link.
The port not connected with the point-to-point link cannot transit fast.
The master ports of the link aggregation and the ports operating in full-duplex mode are
connected to the point-to-point link. You are recommended to keep the default settings
and let MSTP detect the link state automatically.
To Next Page
Loading...
