Command Manual – VLAN&QinQ
Quidway S8500 Series Routing Switches Chapter 1
VLAN Configuration Commands
Huawei Technologies Proprietary
1-3
Description : Vlan-interface1 Interface
The Maximum Transmit Unit is 1500
Table 1-1 Description on the fields of the display interface Vlan-interface command
Field Description
Vlan-interface1 current state Current state of the VLAN interface
Line protocol current state Current state of the Line protocol
IP Sending Frames' Format Format of the IP sending frames
Hardware address
Corresponding MAC address of the
VLAN interface
Internet Address IP address
Description Description of the VLAN interface
The Maximum Transmit Unit Maximum Transmit Unit (MTU)
1.1.4 display vlan
Syntax
display vlan [ vlan-id to vlan-id | all | static | dynamic ]
View
Any view
Parameter
vlan-id: Displays information of the specified VLAN.
all: Displays information of all VLANs.
static: Displays information of VLANs created statically by the system.
dynamic: Displays information of VLANs created dynamically by the system.
Description
Use the display vlan command to view related information about the specified or all
VLANs.
If vlan-id or all is specified, information of specified VLAN or all VLANs is displayed. It
includes: VLAN ID, VLAN type (dynamic or static), whether the routing function has
been enabled on this VLAN (if enabled, the main IP address and mask will be
displayed), VLAN description, and the ports VLAN contains.
If parameter is not specified, information of the VLANs that has been created is
displayed. If the parameter dynamic or static is selected, information of VLANs created
dynamically or statically by the system is displayed.
To Next Page
Loading...
Need help?
General