Command Manual – Multicast Protocol
Quidway S8500 Series Routing Switches Chapter 3 Multicast Common Configuration Commands
Huawei Technologies Proprietary
3-14
Parameter
limit: Limits the capacity of multicast routing table.
Description
Use the multicast route-limit command to limit the capacity of multicast routing table.
When the preset capacity is exceeded, the router will discard new (S, G) protocol and
data packets.
Use the undo multicast route-limit command to restore the limit to the default value.
By default, the capacity of multicast routing table is set to 512.
If the existing route entries exceed the capacity value you configured during using this
command, the system will not delete the existing entries, but prompts the information
“Existing route entries exceed the configured capacity value”.
The new configuration overwrites the old one if you run the command for a second
time.
Example
# Limit multicast routing table capacity at 128.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] multicast route-limit 128
3.1.13 multicast routing-enable
Syntax
multicast routing-enable
undo multicast routing-enable
View
System view
Parameter
None
Description
Use the multicast routing-enable command to enable multicast routing.
Use the undo multicast routing-enable command to disable multicast routing.
By default, multicast routing is disabled.
Related commands: pim dm, pim sm, igmp enable.
To Next Page
Loading...
Need help?
General