Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-5
event: Enables/Disables OSPF event debugging.
packet: Enables/Disables OSPF packet debugging. OSPF packets include:
ack: LSAck packet.
dd: Database Description packet.
hello: Hello packet.
request: Link State Request packet.
update: Link State Update packet.
interface interface-type interface-number: Interface type and number, which indicates
to enable/disable debugging for the OSPF packets obtained on the specified interface.
lsa-originate: Enables/Disables OSPF LSA packet debugging.
spf: Enables/Disables OSPF minimum tree calculation debugging.
Description
Use the debugging ospf command to enable OSPF process debugging.
Use the undo debugging ospf command to disable OSPF process debugging.
If you do not specify a process ID, the command is applied to all processes. While the
router is operating, the debugging state always remains regardless of the existing
OSPF process. If you specify a process ID, the command is only applied to the
specified process.
Related command: display debugging ospf.
Example
# Enable OSPF packet debugging.
<Quidway> debugging ospf packet
3.1.6 default cost
Syntax
default cost value
undo default cost
View
OSPF view
Parameter
value: Default routing cost of an external route imported by OSPF, ranging from 0 to
16,777,214. By default, its value is 1.
To Next Page
Loading...
