Huawei Quidway S8500 Series - Display Ip Routing-Table Protocol

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches Chapter 1 Static Route Configuration Commands
Huawei Technologies Proprietary
1-10
Destination/Mask Protocol Pre Cost Nexthop Interface
10.1.0.0/16 STATIC 60 0 48.48.48.2 Vlan-interface48
10.1.1.0/24 STATIC 60 0 48.48.48.2 Vlan-interface48
10.1.1.2/32 STATIC 60 0 48.48.48.2 Vlan-interface48
STATIC Routing table status:<inactive>:
Summary count: 0
<Quidway> display ip routing-table ip-prefix abc2
Routes matched by ip-prefix abc2:
Summary count: 2
Destination/Mask Protocol Pre Cost Nexthop Interface
10.1.1.0/24 STATIC 60 0 48.48.48.2 Vlan-interface48
10.1.1.2/32 STATIC 60 0 48.48.48.2 Vlan-interface48
For detailed description of the output information, see Table 1-1.
# Display the details of the active and inactive routes filtered by the prefix list abc2.
<Quidway> display ip routing-table ip-prefix abc2 verbose
Routes matched by ip-prefix abc2:
Generate Default: no
+ = Active Route, - = Last Active, # = Both * = Next hop in use
Summary count: 2
**Destination: 10.1.1.0 Mask: 255.255.255.0
Protocol: #STATIC Preference: 60
*NextHop: 48.48.48.2 Interface: 48.48.48.1(Vlan-interface48)
Vlinkindex: 0
State: <Int ActiveU Gateway Static Unicast>
Age: 12:42 Cost: 0/0 Tag: 0
**Destination: 10.1.1.2 Mask: 255.255.255.255
Protocol: #STATIC Preference: 60
*NextHop: 48.48.48.2 Interface: 48.48.48.1(Vlan-interface48)
Vlinkindex: 0
State: <Int ActiveU Gateway Static Unicast>
Age: 12:48 Cost: 0/0 Tag: 0
For explanations of the above information, see Table 1-2.
1.1.6 display ip routing-table protocol
Syntax
display ip routing-table protocol protocol [ inactive | verbose ] [ vpn-instance
vpn-instance-name ]