Command Manual – Integrated Management
Quidway S8500 Series Routing Switches Chapter 1
HGMP V1 Configuration Commands
Huawei Technologies Proprietary
1-27
Example
# Configure the port 1 of the Ethernet switch with a position parameter of 3/1/6-/ to
operate at a speed of 10 Mbps and in full duplex mode.
[Quidway-lanswitch3/1/6-/]set workmode 1 10m-full
Waiting.....
Operating LANSWITCH[3/1/6-/]'s ports successfully!
1.3 Configuration Commands for
S2008B/S2016B/S2026B/S3026 Series Switches
 Note:
The following commands are only applicable to S2008B/S2016B/S2026B/S3026 series
switches.
1.3.1 add addritem
Syntax
add addritem mac-addr { unicast port [ aged | noaged | permanent ] | multicast
vlanid port-list mctype }
View
lanswitch view
Parameter
mac-addr: MAC address to be added.
unicast: Specifies the address as a unicast address.
port: Port used to unicast.
aged: Specifies to delete the address if it is aged.
noaged: Specifies the address is not aged.
permanent: Specifies the address can be written to the flash memory.
multicast: Specifies the address is a multicast address.
vlanid: VLAN ID of the multicast group.
port-list: Port list of the multicast group.
mctype: Specifies how the multicast group forward data to the CPU.
z no: Specifies not to forward data to the CPU.
To Next Page
Loading...
Need help?
General