Huawei Quidway S8500 Series User Manual

Command Manual – Integrated Management
Quidway S8500 Series Routing Switches Chapter 1
HGMP V1 Configuration Commands
Huawei Technologies Proprietary
1-50
Parameter
agedtimevalue: the address aged time in seconds. If the value is 0, it means the
address will not be aged.
Description
Use the set address agedtime command to set the address aged time of the switch.
Example
# Set the address aged time of the Ethernet switch with the position parameter of
“8/1/1-/” as 100 seconds.
[Quidway-lanswitch8/1/1-/] set address agedtime 100
Waiting.....
Config address aged time successfully!
 Note:
This command is only applicable to the configuration of S2008B, S2026B and S2016B
Ethernet switches on the NMS.
1.3.27 set config-flash
Syntax
set config-flash { write | erase }
View
lanswitch view
Parameter
write: Specifies to write the configuration file to the flash memory.
erase: Specifies to remove the configuration file saved in the flash memory.
Description
Use the set config-flash command to save/remove the configuration file in/from the
flash memory.
Example
# Write the current configuration file to the flash memory.
[Quidway-lanswitch3/1/3-/] set config-flash write

Huawei Quidway S8500 Series Specifications

General

Brand	Huawei
Model	Quidway S8500 Series
Category	Switch
Language	English