Command Manual – Security
Quidway S8500 Series Routing Switches Chapter 1
802.1x Configuration Commands
Huawei Technologies Proprietary
1-13
1.1.12 dot1x supp-proxy-check
Syntax
dot1x supp-proxy-check { logoff | trap } [ interface interface-list ]
undo dot1x supp-proxy-check { logoff | trap } [ interface interface-list ]
View
System view, Ethernet interface view
Parameter
logoff: Cuts network connection to a user upon detecting the use of proxy.
trap: Sends trap message upon detecting a user using proxy to access the switch.
interface interface-list: Ethernet interface list expressed in the format interface-list
=interface-type interface-number [ to interface-type interface-number ] &<1-10>.
interface-type means the interface type, interface-number is the interface number.
Refer to command parameters in the “Port” section in the manual for the respective
meanings and value ranges of them. The interface number after the key word to should
be no smaller than the interface number before to. &<1-10> in the command means
that the preceding parameter can be entered up to 10 times.
Description
Use the dot1x supp-proxy-check command to configure the control method for
802.1x access users via proxy logon the specified interface.
Use the undo dot1x supp-proxy-check command to cancel the control method set for
the 802.1x access users via proxy.
Note that when performing this function, the user logging on via proxy need to run
Huawei 802.1x client program,( Huawei 802.1x client program version V1.29 or above
is needed).
This command is used to set on the specified interface when executed in system view.
The parameter interface-list cannot be input when the command is executed in
Ethernet Port view and it has effect only on the current interface. After globally enabling
proxy user detection and control in system view, only if you enable this feature on a
specific port can this configuration take effects on the port.
Related command: display dot1x.
Example
# Configure the switch cut network connection to a user upon detecting the use of proxy
on Ethernet 2/1/1 ~ Ethernet 2/1/8.
[Quidway] dot1x supp-proxy-check logoff
To Next Page
Loading...
Need help?
General