Command Manual – NAT&URPF&VPLS
Quidway S8500 Series Routing Switches Chapter 1
NAT Configuration Commands
Huawei Technologies Proprietary
1-6
Field Description
active SERVER session table count Number of user-configured internal servers
the number of good packet in NP Number of correct packets received by NP
the number of bad packet in NP Number of wrong packets received by NP
1.1.7 nat address-group
Syntax
nat address-group group-number start-addr end-addr
undo nat address-group group-number
View
System view
Parameter
group-number: Group number of an address pool, in the range 0 to 319.
start-addr: Starting IP address of an address pool.
end-addr: Ending IP address of an address pool.
Description
Use the nat address-group command to configure an address pool.
Use the undo nat address-group command to delete an address pool.
An address pool is a group of some external IP addresses. If start-addr and end-addr
are the same, there is only one address.
Caution:
z The number of addresses included in an address pool (the number of the public
addresses in an address pool) must not exceed 256.
z You cannot configure network segment addresses and broadcast addresses as
addresses in an address pool.
z The IP addresses configured in the NAT address pool must not be the same with the
IP addresses in the internal network.
z You cannot delete an address pool that is associated to an ACL.
z When NAPT is enabled, there cannot be more than 3 addresses in an address pool.
To Next Page
Loading...
Need help?
General