Command Manual – Security
Quidway S8500 Series Routing Switches Chapter 1
802.1x Configuration Commands
Huawei Technologies Proprietary
1-16
interaction process. It could be necessary for some special and hard network
environment. Generally, the user should keep the default values of the timers.
Related command: display dot1x.
Example
# Set the Authentication Server timeout timer is 150s.
[Quidway] dot1x timer server-timeout 150
1.1.14 reset dot1x statistics
Syntax
reset dot1x statistics [ interface interface-list ]
View
User view
Parameter
interface interface-list: Ethernet interface list expressed in the format interface-list
=interface-type interface-number [ to interface-type interface-number ] &<1-10>.
interface-type means the interface type; interface-number is the interface number.
Refer to command parameters in the “Port” section in the manual for the respective
meanings and value ranges of them. The interface number after the key word to should
be no smaller than the interface number before to. &<1-10> in the command means
that the preceding parameter can be entered up to 10 times.
Description
Use the reset dot1x statistics command to reset the statistics of 802.1x.
This command can be used to re-perform information statistics if the user wants to
delete the former statistics of 802.1x.
When the original statistics is cleared, if no port type or port number is specified, the
global 802.1x statistics of the switch and 802.1x statistics on all the ports will be cleared.
If the port type and port number are specified, the 802.1x statistics on the specified port
will be cleared.
Related command: display dot1x.
Example
# Clear the 802.1x statistics on Ethernet 3/1/2.
<Quidway> reset dot1x statistics interface Ethernet 3/1/2
To Next Page
Loading...
