Command Manual – MPLS
Quidway S8500 Series Routing Switches Chapter 3 MPLS L2VPN Configuration Commands
Huawei Technologies Proprietary
3-6
3.2 Martini MPLS L2VPN Configuration Commands
3.2.1 display mpls l2vc
Syntax
display mpls l2vc [ interface vlan-interface vlan-id | verbose | block | peer | up |
vsi ]
View
Any view
Parameter
vlan-id: ID of the VLAN whose interface is used to create the virtual circuit.
verbose: Displays the detailed information.
block: Displays only the VC information in Block state.
peer: Specifies Remote Peer.
up: Displays only the VC information in UP state.
vsi: Specifies VSI instance.
Description
Use the display mpls l2vc command to display the information about the virtual circuit
(VC) created using label distribution protocol (LDP).
Example
# Display the information about MPLS LDP connections.
<Quidway> display mpls l2vc verbose
Interface: Vlan-interface1000State: down, Encapsulation: ethernet, Service:
VLL
VC-ID: 4294967295, VC State: down, Destination: 3.3.3.3
Group ID: Local 0, Remote 0, VC Label: Local 32770, Remote 0,
Tunnel Type: LSP, Tunnel Index: 25
Interface: Vlan-interface1001State: down, Encapsulation: ethernet, Service:
VLL
VC-ID: 10001, VC State: down, Destination: 1.1.1.1
Group ID: Local 0, Remote 0, VC Label: Local 32771, Remote 0,
Tunnel Type: LSP, Tunnel Index: 23