Command Manual – Security
Quidway S8500 Series Routing Switches
Chapter 2 AAA and RADIUS/HWTACACS Protocol
Configuration Commands
Huawei Technologies Proprietary
2-53
hwtacacs-scheme-name, a character string not exceeding 32 characters, excluding
“?”.
Description
Use the display stop-accounting-buffer command to view information on the
stop-accounting requests buffered in the switch.
Related command: reset stop-accounting-buffer, stop-accounting-buffer enable,
retry stop-accounting.
Example
# Display information on the buffered stop-accounting requests related to the
HWTACACS scheme “huawei".
<Quidway> display stop-accounting-buffer hwtacacs-scheme huawei
%No accounting stop packet exists.
2.3.5 hwtacacs nas-ip
Syntax
hwtacacs nas-ip ip-address
undo hwtacacs nas-ip
View
System view
Parameter
ip-address: IP address of a specified source, which is that of the local host and cannot
be a broadcast address of class A, B or C, a class D address, an all-zero address, or an
address begins with 127.
Description
Use the hwtacacs nas-ip command to specify the source address of the HWTACACS
packet sent from NAS.
Use the undo hwtacacs nas-ip command to restore the default setting.
By specifying the source address of the HWTACACS packet, you can avoid
unreachable packets as returned from the server upon interface failure. The source
address is normally recommended to be a loopback interface address.
For the hwtacacs nas-ip command, the HWTACACS view takes precedence over the
system view.
By default, the source address is not specified, that is, the address of the interface
sending the packet serves as the source address.
To Next Page
Loading...
