Huawei Quidway S8500 Series - Display Mpm Forwarding-Table

Command Manual – Multicast Protocol
Quidway S8500 Series Routing Switches Chapter 3 Multicast Common Configuration Commands
Huawei Technologies Proprietary
3-4
View
User view
Parameter
None
Description
Use the debugging multicast status-forwarding command to enable multicast
forwarding status debugging functions.
Use the undo debugging multicast status-forwarding command to disable the
debugging functions.
By default, the multicast forwarding status debugging is disabled.
Example
# Enable multicast forwarding status debugging functions.
<Quidway> debugging multicast status-forwarding
3.1.5 display mpm forwarding-table
Syntax
display mpm forwarding-table [ group-address | source-address ]
View
Any view
Parameter
group-address: Multicast group address, used to specify a multicast group, ranging
from 224.0.0.0 to 239.255.255.255.
source-address: IP address of the multicast source.
Description
Use the display mpm forwarding-table command to view the port-carrying multicast
forwarding table information.
When a group address or a source address is specified, this command shows only the
matched (S, G) entry; otherwise, this command shows all entries.
Related command: display multicast forwarding-table
Example
# View the port-carrying multicast forwarding table information.
<Quidway> display mpm forwarding-table