Command Manual – System Management
Quidway S8500 Series Routing Switches Chapter 1 File System Management Commands
Huawei Technologies Proprietary
1-18
The displayed information is global, port and user configurations.
1.2.3 display this
Syntax
display this
View
Any view
Parameter
None
Description
Use the display this command to display the running configuration of the current view.
If you need to authenticate whether the configurations is correct after you have finished
a set of configurations under a view, you can use the display this command to view the
running parameters.
Some effective parameters are not displayed if they are the same with the default ones,
while some parameters, though have been configured by the user, if their related
functions are not effective, are not displayed either. For example, if X.25 is
encapsulated at the data link layer on an interface, you can configure PPP parameter
on the interface, but cannot view the configuration information when executing the
display this command.
Associated configuration of the interface is displayed when executing the command in
different interface views; related configuration of the protocol view is displayed when
executing this command in different protocol views; and all the configuration of the
protocol view is displayed when executing this command in protocol sub-views.
Related command: save, reset saved-configuration, display current-configuration,
display saved-configuration.
Example
# Display the running configuration parameters for the current view of the switch
system.
<Quidway> display this
1.2.4 display startup
Syntax
display startup
To Next Page
Loading...
